2
FCC STATEMENT:
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE
MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE
THAT MAY CAUSE UNDESIRED OPERATION.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO
THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER'S AUTHORITY TO OPERATE THE EQUIPMENT.
This equipment generates and uses radio frequency energy and if not installed and used properly, that is, in strict accordance with the manufacturer's
instructions, may cause Interference to radio and television reception. It has been type tested. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• If using an indoor antenna, have a quality outdoor antenna installed.
• Reorient the receiving antenna until interference is induced or eliminated.
• Move the receiver away from the security control.
• Move the antenna leads away from any wire runs to the security control
• Have the device or controller plugged into a different outlet so that it and the receiver are on different branch circuits.
If necessary, the user should consult the dealer or an experienced radio/television technician for additional suggestions. The user or installer may
find a booklet titled "Interference Handbook" prepared by the Federal Communications Commission helpful: This booklet is available from the U.S.
Government Printing Office, Washington, DC 20402. The user shall not make any changes or modifications to the equipment unless authorized by the
Installation Instructions or Users Manual. Unauthorized changes or modifications could void the user's authority to operate the equipment.
“Australia’s largest designer
and manufacturer of
high quality security products”
www.ness.com.au
WARNING
Installation and maintenance shall be performed by
qualified service personnel only.
CAUTION
Risk of explosion if battery is replaced by an
incorrect type. Dispose of used batteries according
to the instructions on the battery.
HEAD OFFICE & MANUFACTURING
Ness Security Products Pty Ltd
ABN 28 069 984 372
4 / 167 Prospect Hwy
Seven Hills NSW 2147 Australia
Ph +61 2 8825 9222 Fax +61 2 9838 8508
ness@ness.com.au
DISTRIBUTED IN USA BY:
The Systems Depot
3266 US Hwy 70 West
Connelly Springs, NC 28612
Ph: 877 254 2172 Fax: 828 397 4212
GUARDPOST Wireless Alarm System with GSM Communicator FCC ID: O2K-106058
Contains GSM/GPRS Modem Transmitter Module FCC ID: MIVGSM0108
Wireless Mini Door & Window Switch Transmitter (RR1) FCC ID: O2K-106064
Wireless Universal Transmitter w/ext input & Vib analyser (RR2) FCC ID: O2K-106065
Wireless 4 Button Keyfob Transmitter (RK4) FCC ID: O2K-106068
Wireless 3 Button Keyfob Transmitter (RK3) FCC ID: O2K-MK304
Wireless 1 Button Bracelet / Neckless Panic Transmitter (RK1) FCC ID: O2K-106050
Wireless Emergency Button Transmitter (RPB) FCC ID: O2K-106054
Wireless Door Bell Button Transmitter (RDB) FCC ID: O2K-106056
Wireless PIR with Pet Immunity (R15PET) FCC ID: O2K-106051
Wireless PIR - Non Pet Immune (R15) FCC ID: O2K-SPIR304
Swivel Mounting Bracket for Wireless PIR FCC ID: N/A
To Next Page
Loading...
Need help?
General
