Ness M1 - Page 2


 
Page2 NessM1Z‐WaveGatewaySetupGuide
1.1 SettingUptheM1XEP
BeforeanythingcanbesetupintheM1Z‐WaveGateway,thereisafewstepsyou
needtocheckandsetupintheM1XEP(EthernetModule).
1. OpenyourM1AccountinElkRP,andconnecttoyourpanelviatheM1XEP.


2. Onceconnected,fromthe‘accountsdetails’page,clickontheM1XEPSetup
button.

3. Selectthe‘TCP/IPSettings’tabandensureyouhavetheIPaddresssetasastatic
IPaddress.Alsoensureyouhaveenabledthenon‐securePort.Keepnoteof
bothsettingsasyouwillneedthisforlateron.Ifyoumakeanychanges,press
the‘send’buttonatthebottomofthepagetosendthesettingstotheM1XEP.
