nested Cozi Sleeper - Height Adjustment; Adjusting Crib Height; Co-Sleeper Mode; Using Co-Sleeper Mode

Page 38
Height Adjustment
EN
The crib has 5 height positions.
1. Press in the adjustment lever and adjust the crib to the desired height.
Repeat this operation on the opposite side.
WARNING! Ensure the spring pin has clicked into position before placing baby in crib.
2
. The base of the crib can be inclined slightly by adjusting the two legs to dierent heights.
The crib can be inclined with a maximum variance of 2 positions between one leg and the other
(e.g. the right leg in position 3 and the left leg in position 1).
WARNING! The head of the child should always be positioned on the highest side.
Co-Sleeper Mode
1. Open the crib side using the side zips. Ensure they are fully open.
2. Open the zipper located underneath the padded top rail.
Release the studs from the tubing and partially remove the tubes. Once this operation has been performed
on both sides, lower the side of crib and attach it to the base of the crib main body using press studs.
Close the zipper to cover the joint.
WARNING! Use the crib with the side panel lowered in “co-sleeping mode” only.
3. Move the crib close to the adult bed and check the height of the crib compared with the mattress of
the bed.
WARNING! The height of the adult mattress should always be more than that of the side support for
containment of the crib.
WARNING! In “co-sleeping mode” the 2 legs of the crib should always be adjusted to the same height.
4. Use the three straps (D) provided to x crib to the adult bed.
NOTE. when crib body is rst removed from packaging, the middle strap is assembled. It diers slight to
the left and right strap. Fasten the middle strap buckle to the crib. Insert buckle into slot located
underneath the crib body and fasten.
5. Fasten the second strap buckle to the inner side of the left frame. Repeat with the third strap buckle to
the inner side of the right frame.
NOTE. both buckles attached to the frame have the same end of the support strap.
6. Loop the rst middle strap around the frame of the adult bed, from the bottom towards the top and
fasten the buckle to nish. Repeat for the other two straps on both inner side of the crib frame.
WARNING! Ensure all webbing strap buckles are fastened before continuing.