NetApp AFF A Series User Manual

a. Firmly push the controller module into the chassis until it meets the midplane and is fully seated.
The locking latches rise when the controller module is fully seated.
Do not use excessive force when sliding the controller module into the chassis to avoid
damaging the connectors.
The controller module begins to boot as soon as it is fully seated in the chassis.
b. Rotate the locking latches upward, tilting them so that they clear the locking pins, and then lower them
into the locked position.
c. If you have not already done so, reinstall the cable management device.
6.
Return the controller to normal operation by giving back its storage:
storage failover giveback
-ofnode impaired_node_name
7.
If automatic giveback was disabled, reenable it:
storage failover modify -node local -auto
-giveback true
Step 5: Return the failed part to NetApp
Return the failed part to NetApp, as described in the RMA instructions shipped with the kit. See the
Part Return
& Replacements
page for further information.
Replace a power supply - AFF A800
Before you begin
Replacing a power supply (PSU) involves disconnecting the target PSU from the power
source, unplugging the power cable, removing the old PSU and installing the replacement
PSU, and then reconnecting it to the power source.
• The power supplies are redundant and hot-swappable.
• This procedure is written for replacing one PSU at a time.
It is a best practice to replace the PSU within two minutes of removing it from the chassis.
The system continues to function, but ONTAP sends messages to the console about the
degraded PSU until the PSU is replaced.
Do not mix PSUs with different efficiency ratings or different input types. Always replace like
for like.
Use the appropriate procedure for your type of PSU; AC or DC.
673

NetApp AFF A Series Specifications

General

Brand	NetApp
Model	AFF A Series
Category	Server
Language	English