ONTAP Configuration Guide
7. Set up your account and download Active IQ Config Advisor:
a. Log in to your existing account or create an account.
NetApp Support Registration
b. Register your system.
NetApp Product Registration
c. Download Active IQ Config Advisor.
NetApp Downloads: Config Advisor
8. Verify the health of your system by running Config Advisor.
9. After you have completed the initial configuration, go to the
ONTAP & ONTAP System Manager
Documentation Resources
page for information about configuring additional features in ONTAP.
Option 2: Completing system setup and configuration if network discovery is not enabled
If network discovery is not enabled on your laptop, you must complete the configuration and setup using this
task.
1. Cable and configure your laptop or console:
a. Set the console port on the laptop or console to 115,200 baud with N-8-1.
See your laptop or console’s online help for how to configure the console port.
b. Connect the console cable to the laptop or console using the console cable that came with your
system, and then connect the laptop to the management switch on the management subnet .
c. Assign a TCP/IP address to the laptop or console, using one that is on the management subnet.
2. Use the following animation to set one or more drive shelf IDs:
Animation - Set drive shelf IDs
If your system has NS224 drive shelves, the shelves are pre-set to shelf ID 00 and 01. If you want to
change the shelf IDs, you must create a tool to insert into the hole where button is located.
Animation - Set drive shelf IDs
3. Plug the power cords into the controller power supplies, and then connect them to power sources on
different circuits.
FAS8300 and FAS8700 shown.
Animation - Power on the controllers
Initial booting may take up to eight minutes.
4. Assign an initial node management IP address to one of the nodes.
332
To Next Page
Loading...
