NetApp AFF A150 - Page 728

If the command fails, contact Customer Support.
◦
If the
Key Manager type = onboard and the Restored column = anything other than yes/true,
use the security key-manager onboard sync command to re-sync the Key Manager type.
Use the
security key-manager key-query command to verify that the Restored column =
yes/true for all authentication keys.
11. Connect the console cable to the partner controller.
12. Give back the controller using the storage failover giveback -fromnode local command.
13.
Restore automatic giveback if you disabled it by using the
storage failover modify -node local
-auto-giveback true
command.
Return the failed part to NetApp - AFF A900
Return the failed part to NetApp, as described in the RMA instructions shipped with the
kit. See the
Part Return & Replacements page for further information.
Chassis
Replace the chassis - AFF A900
About this task
To replace the chassis, you must remove the power supplies, fans, controller modules,
I/O modules, DCPM modules, and USB LED module from the impaired chassis, remove
the impaired chassis from the equipment rack or system cabinet, install the replacement
chassis in its place, and then install the components into the replacement chassis.
All other components in the system must be functioning properly; if not, you must contact technical support.
• You can use this procedure with all versions of ONTAP supported by your system.
• This procedure is disruptive. For a two-node cluster, you will have a complete service outage and a partial
outage in a multi-node cluster.
Shutdown the controllers - AFF A900
This procedure is for 2-node, non-MetroCluster configurations only. If you have a system
with more than two nodes, see
How to perform a graceful shutdown and power up of one
HA pair in a 4-node cluster
.
Before you begin
You need:
• Local administrator credentials for ONTAP.
• NetApp onboard key management (OKM) cluster-wide passphrase if using storage encryption.
• SP/BMC accessability for each controller.
• Stop all clients/host from accessing data on the NetApp system.
• Suspend external backup jobs.
726