3. Recable the I/O module, as needed.
4. Repeat the preceding step for the remaining I/O modules that you set aside.
If the impaired chassis has blank I/O panels, move them to the replacement chassis at this
time.
Step 11: Install the power supplies
Installing the power supplies when replacing a chassis involves installing the power supplies into the
replacement chassis, and connecting to the power source.
1. If you are not already grounded, properly ground yourself.
2. Make sure the power supplies rockers are in the off position.
3. Using both hands, support and align the edges of the power supply with the opening in the system chassis,
and then gently push the power supply into the chassis until it locks into place.
The power supplies are keyed and can only be installed one way.
Do not use excessive force when sliding the power supply into the system. You can damage
the connector.
4. Reconnect the power cable and secure it to the power supply using the power cable locking mechanism.
Only connect the power cable to the power supply. Do not connect the power cable to a
power source at this time.
5. Repeat the preceding steps for any remaining power supplies.
Step 12 Install the USB LED modules
Install the USB LED modules in the replacement chassis.
1. Locate the USB LED module slot on the front of the replacement chassis, directly under the DCPM bays.
2. Align the edges of the module with the USB LED bay, and gently push the module all the way into the
chassis until it clicks into place.
Step 13: Install the controller
After you install the controller module and any other components into the replacement chassis, boot it to a
state where you can run the interconnect diagnostic test.
1. If you are not already grounded, properly ground yourself.
2. Connect the power supplies to different power sources, and then turn them on.
3. Align the end of the controller module with the opening in the chassis, and then gently push the controller
module halfway into the system.
Do not completely insert the controller module in the chassis until instructed to do so.
4. Recable the console to the controller module, and then reconnect the management port.
737
To Next Page
Loading...
