The following video shows how to install and cable your new system.
"Animation - Installation and Setup of an ASA C800
== Video two of two: Perform end-to-end software configuration
The following video shows end-to-end software configuration for systems running ONTAP 9.2 and later.
[] | https://img.youtube.com/vi/WAE0afWhj1c?/maxresdefault.jpg
= Detailed steps - ASA C800
:icons: font
:relative_path: ./asa-c-800/
:imagesdir: /tmp/d20231020-12297-25s5m0/source/./asa-c-250/../media/
This section gives detailed step-by-step instructions for installing an ASA C800
system.
== Step 1: Prepare for installation
To install your ASA C800 system, you need to create an account and register the system. You also need
to inventory the appropriate number and type of cables for your system and collect specific network
information.
You need to have access to the
NetApp Hardware Universe (HWU) for information about site
requirements as well as additional information on your configured system. You might also want to have
access to the Release Notes for your version of ONTAP for more information about this system.
What you need
You need to provide the following at your site:
• Rack space for the storage system
• Phillips #2 screwdriver
• Additional networking cables to connect your system to your network switch and laptop or console
with a Web browser
1. Unpack the contents of all boxes.
2. Record the system serial number from the controllers.
Steps
1. Set up your account:
a. Log in to your existing account or create an account.
b. Register (NetApp Product Registration) your system.
2. Download and install
NetApp Downloads: Config Advisor on your laptop.
3. Inventory and make a note of the number and types of cables you received.
The following table identifies the types of cables you might receive. If you receive a cable not listed in
the table, see the
NetApp Hardware Universe to locate the cable and identify its use.
210
To Next Page
Loading...
