a. Open File Explorer.
b. Click Network in the left pane.
c. Right-click and select refresh.
d. Double-click either ONTAP icon and accept any certificates displayed on your screen.
XXXXX is the system serial number for the target node.
System Manager opens.
5. Use System Manager guided setup to configure your system using the data you collected in the
ONTAP Configuration Guide.
6. Verify the health of your system by running Config Advisor.
7. After you have completed the initial configuration, go to the ONTAP & ONTAP System Manager
Documentation Resources
page for information about configuring additional features in ONTAP.
=== Option 2: Complete system setup and configuration if network discovery is not enabled
If network discovery is not enabled on your laptop, you must complete the configuration and setup using
this task.
Steps
1. Cable and configure your laptop or console:
a. Set the console port on the laptop or console to 115,200 baud with N-8-1.
See your laptop or console’s online help for how to configure the console port.
b. Connect the console cable to the laptop or console, and connect the console port on the controller
using the console cable that came with your system.
[drw console connect asac800] | ../media/drw_console_connect_asac800.png
c. Connect the laptop or console to the switch on the management subnet.
[drw client mgmt subnet asac800] | ../media/drw_client_mgmt_subnet_asac800.png
d. Assign a TCP/IP address to the laptop or console, using one that is on the management subnet.
2. Plug the power cords into the controller power supplies, and then connect them to power sources on
different circuits.
The system begins to boot. Initial booting may take up to eight minutes.
3. Assign an initial node management IP address to one of the nodes.
If the management network
has DHCP…
Then…
Configured Record the IP address assigned to the new controllers.
218
To Next Page
Loading...
