Animation - Cable the controllers to two drive shelves
Step Perform on each controller module
Cable controller A to the shelves: [drw asac800 2shelf cabling a]
Cable controller B to the shelves: [drw asac800 2shelf cabling b]
To complete setting up your system, see
Step 4: Complete system setup and configuration.
== Step 4: Complete system setup and configuration
Complete the system setup and configuration using cluster discovery with only a connection to the switch
and laptop, or by connecting directly to a controller in the system and then connecting to the management
switch.
=== Option 1: Complete system setup and configuration if network discovery is enabled
If you have network discovery enabled on your laptop, you can complete system setup and configuration
using automatic cluster discovery.
Steps
1. Plug the power cords into the controller power supplies, and then connect them to power sources on
different circuits.
The system begins to boot. Initial booting may take up to eight minutes.
2. Make sure that your laptop has network discovery enabled.
See your laptop’s online help for more information.
3. Use the animation to connect your laptop to the Management switch:
Animation - Connect your laptop to the Management switch
4. Select an ONTAP icon listed to discover:
217
To Next Page
