NetApp FAS User Manual

If your system is in… Then perform these steps…
An HA pair The controller module begins to boot as soon as it is fully seated in
the chassis. Be prepared to interrupt the boot process.
a. With the cam handle in the open position, firmly push the
controller module in until it meets the midplane and is fully seated,
and then close the cam handle to the locked position.
Do not use excessive force when sliding the
controller module into the chassis to avoid
damaging the connectors.
The controller begins to boot as soon as it is seated in the
chassis.
b. If you have not already done so, reinstall the cable management
device.
c. Bind the cables to the cable management device with the hook
and loop strap.
d.
When you see the message
Press Ctrl-C for Boot Menu,
press
Ctrl-C to interrupt the boot process.
If you miss the prompt and the controller module
boots to ONTAP, enter
halt, and then at the
LOADER prompt enter
boot_ontap, press Ctrl-
C
when prompted, and then boot to Maintenance
mode.
e. Select the option to boot to Maintenance mode from the displayed
menu.
171

NetApp FAS Specifications

General

Brand	NetApp
Model	FAS
Category	Disk array system
Language	English