www.netcomm.com.au Rev. 1 - YML668
Page 16 NP5400 11g Wireless Access Point User Guide
The Info Tab
The Info Tab displays the current AP settings.
Access Point Information
Access point name: Displays current device name of the AP. You also can change
the name.
MAC address of AP: Displays the unique fMAC number burned into this AP that
identifies itself from other Ethernet devices
Associated stations: Displays the number of wireless client devices associated
with this AP.
Wireless Firmware version: Displays the version number of wireless LAN firmware
embedded in this AP.
AP version: Displays the version number of AP system firmware.
Current IP settingsIP address: Displays the current IP address of this AP.
DHCP client: Displays if this AP enable DHCP client feature or not.
Current Wireless
SettingsPerformance Mode: Displays the AP is set in Maximum interoperability mode or
Maximum performance mode.
Wireless network name (SSID): Displays current SSID of the AP. Please make sure that
your wireless LAN is working properly under the effective
reach range of the AP
WEP: Displays the WEP function is enabled or disabled.
To Next Page
Loading...
