Distribué par / Distributed by / Distribuito da NETELEC SRL FR - rue Philemon Laugier - 83400 Hyeres les Palmiers
2. INSTALLATION
NOTE: The fixture must be properly grounded to avoid accidental power leakage and electric shock
A qualified electrician must install the fixture. Before installing be sure to turn the power off
1．Take down the plastic shade;
2．Hold base against the wall and mark drill holes, paying attention to any existing
wiring in the wall;
3．Drill the holes, insert wall plugs;
4．Put the power wire and load wire through the base holes;
5．Screw the base into place. Make sure all the screws fasten when installation.
6．According to the input line of lamp’s terminal instruction，zero wire, live wire and
ground wire shall be corresponding connection with the reliability;
7．Connect N↑, ↑, L↑,with power supply
8．Fit plastic shade and test it for proper operation.
To Next Page
Loading...
Need help?
General