Distribué par / Distributed by / Distribuito da NETELEC SRL FR - rue Philemon Laugier - 83400 Hyeres les Palmiers
5. INITIAL VERIFICATION / DEFECTS AND RESOLUTION
• After unpacking the appliance, check that it is not broken or damaged.
If in doubt, do not use your device, but rather contact your dealer.
• The device is supplied in a packaging for protection.
- Remove the appliance from all its packaging.
- Clean the device and all accessories of the packaging residues.
• Unscrew the power cable completely.
• Place the device in a suitable place on the mounting bracket.
• Or place the device on a bracket recommended by the manufacturer and suitable for this purpose.
Make sure the bracket is attached to a stable, secure surface.
• Make sure that the length of the power cable is sufficient to power the device.
• Insert the power cable into an appropriate outlet.
6. PROBLEM AND RESOLUTION
• If the product does not work:
- Check that the power cable is properly connected.
- Test the plug by plugging in another device.
• If the plug does not work
- Check the fuses.
- Check if the power cable and plug are damaged. Stop using the device if damage is detected.
7. NOTES OF USE
The product packaging is made of recyclable materials. It can be recycled.
The device must be disposed of properly at the end of its service life in accordance with the statutory
regulations.
The materials must be reused according to their designation. This means that the recyclable material
in the device can be reused and thus contribute to the protection of the environment.
Further information can be obtained from the relevant municipal administrative authorities or from your
local waste disposal company.
To Previous Page
Loading...
Need help?
General