NETGEAR Arlo Baby

15
14
Camera LED Guide
Arlo Baby Characters
• Pull the character ears
up to remove them.
• To install character
ears, align the ears
with the camera lens
and press them onto
the camera.
• Rotate the character
feet and pull them o
to remove them.
• To install character
feet, align the foot
plate with the holes
on the bottom of the
camera and rotate
the foot plate until it
clicks into place.
Arlo Baby cameras come with a bunny character set. You can
remove the bunny character set and replace it with other Arlo
Baby characters.
Solid blue
The camera is
powered on and is
connected to the
Internet.
Fast blinking
amber
The camera is not
connected to a
WiFi network.
Solid amber
The camera is
booting.
O
The camera is
powered o.
Solid purple
The camera is
connected to a WiFi
network. However, it
is not connected to
the Internet.
Blinking purple
The camera is too
far away from the
router.
Blinking blue and
amber
A firmware update
is in progress. DO
NOT TURN OFF THE
CAMERA.
Double blink
amber every 10
seconds
The camera battery
charge is low.
Fast blinking
blue
The camera is
connecting to the
Internet.
Fast blinking
blue for three
seconds
The camera was
connected to a
charger.