Networking
47
N150 and N300 Wireless Routers
The screen adjusts:
6. In the Route Name field, type a name for this static route (for identification purposes only).
7. If you want to limit access to the LAN only
, select the Private check box.
If you select Private, the static route is not reported in RIP.
8. T
o make this route effective, select the Active check box.
By default, the Active check box is selected.
9. T
ype the IP address of the final destination.
10. T
ype the IP subnet mask for this destination. If the destination is a single host, type
255.255.255.255.
11. T
ype the gateway IP address, which must be a router on the same LAN segment as the
Wireless Router.
12. T
ype a number from 1 through 15 as the metric value.
This value represents the number of routers between your network and the destination.
Usually
, a setting of 2 or 3 works, but if this link is a direct connection, set it to 1.
13. Click the Apply button.
The route is added to the table on the Static Routes screen.
To edit a static route:
1. Launch a web browser from a computer or wireless device that is connected to the
network.
2. T
ype http://www.routerlogin.net or http://www.routerlogin.com.
A login screen displays.
3. Enter the router user name and password.
The user name is admin.
The default password is password. The user name and
password are case-sensitive.
The BASIC Home screen displays.
4. Select ADV
ANCED > Advanced Setup > Static Routes.
The Static Routes screen displays.
5. In the table, select the radio button next to the route that you want to edit.
To Next Page
Loading...
Need help?
General
