NETGEAR AC750 JR6150 User Manual

Installation Guide
AC750 Wireless Dual Band Gigabit Router JR6150
Package Contents
Step 1. Step 2. Step 3.
Step 4. Step 5. Step 6.
Unplug the power
to turn off your modem.
Connect one end of the blue
Ethernet cable to your modem,
and the other end to the Internet
port on your router.
Plug in, then turn on your modem.
Connect the power adapter to the
router, then plug it into an outlet.
Wait until the Wireless LED turns
solid green.
Connect the router
to your computer.
Open a browser.
Power adapter Ethernet cable
AC750 Wireless Dual Band Gigabit Router
Internet
DSL
or Cable
Modem
AC750 Wireless Dual
Band Gigabit Router
(not included)
Wait approximately 2 minutes
until your modem turns on.
If your modem has a battery backup,
first remove and reinsert the battery
before connecting your modem to power.
If none of the LEDs light, make sure that the
Power On/Off button is in the on position
(pushed in).
Use another Ethernet cable to establish
a wired connection as shown in this diagram.
(Optionally) Connect wirelessly by using the
preset wireless security settings located
on the bottom label.
If the web page does not display,
close and reopen the browser and
enter http://www.routerlogin.net
in the address bar, or check the
“Troubleshooting” chapter of the
user manual.
Power
On/Off

NETGEAR AC750 JR6150 Specifications

General

Frequency Bands	2.4 GHz and 5 GHz
Wi-Fi Performance	AC750
Antenna	2 external antennas
Parental Controls	Yes
Wireless Standard	802.11ac
Security Features	WPA, WPA2
Key Features	Guest Wi-Fi access
Ethernet Ports	5 (1 WAN and 4 LAN)

Summary

Router Installation Guide

Power Off Modem

Unplug the power to turn off your modem before starting the connection process.

Connect Modem to Router

Connect the modem to the router's Internet port using an Ethernet cable.

Power On Modem

Plug in and turn on your modem, waiting for it to fully start.

Power On Router

Connect the power adapter to the router and plug it into an outlet.

Connect Computer to Router

Establish a wired or wireless connection between your computer and the router.

Open Web Browser

Launch a web browser to access the router's configuration interface.

Wireless Security and Connectivity

Record Default Wireless Settings

Record your unique WiFi network name (SSID) and network key (password) for security.

Manual Connection Method

Connect devices by scanning for the network name (SSID) and entering the password.

WPS (Push 'N' Connect) Method

Connect devices using the WPS button on the router and client device.

ReadySHARE Printer Setup

Product Support and Resources

NETGEAR Genie Utility

Download and install the NETGEAR genie application for network management.