NETGEAR ProSAFE WC7500 Installation Guide

15
• You might not have restarted the computer with the wireless
controller to have TCP/IP changes take effect. Restart the
computer.
• The computer might be set to enable NetBIOS over TCP/IP.
Check that TCP/IP is set to use a static IP address of
192.168.0.210 and a subnet mask of 255.255.255.0. (The default
TCP/IP setting for Windows is to obtain an IP address
automatically.) Restart the computer.
After initial configuration, you cannot access the wireless controller at
its network address. Do the following:
• Use the ping command to verify the connection.
• Verify that the computer and wireless controller are on the same
VLAN.
• Some of the wireless controller’s default settings might not work
with your network. Check the wireless controller’s default settings
against the configuration of other devices in your network.

NETGEAR ProSAFE WC7500 Specifications

General

Brand	NETGEAR
Model	ProSAFE WC7500
Category	Controller
Language	English