NETGEAR ProSAFE WC7500 Installation Guide

14
3. Follow the steps onscreen to discover the access points and review
the discovery results.
4. Select Access Point > Discovery > Managed AP List. Add the
access points that you want to be managed by the wireless
controller to the Managed AP List.
While the access points are converted from standalone mode to
managed mode, the following occurs:
• The wireless controller pushes management firmware onto the
access points.
• The access points become DHCP clients and receive an IP
address from either the DHCP server in your network or the
DHCP server on the wireless controller.
• The profiles that you have configured on the wireless controller
are pushed onto the access points.
Note: For extensive information about the Discovery Wizard and the
discovery process, see the reference manual.
Troubleshooting Tips
You cannot access the wireless controller at its default IP address
(192.168.0.250). Do the following:
• Confirm that the computer is connected to the wireless controller.

NETGEAR ProSAFE WC7500 Specifications

General

Brand	NETGEAR
Model	ProSAFE WC7500
Category	Controller
Language	English