Installation Guide
AC750 Wireless Dual Band Gigabit Router R6050
Package Contents
AC750 Wireless Dual Band Gigabit Router
Power adapter Ethernet cable
Modem
DSL
or Cable
Internet
Power
On/Off
Step 1.
Unplug the power
to turn off your modem.
Step 2.
Connect one end of the blue
Ethernet cable to your modem,
and the other end to the Internet
port on your router.
Step 4.
Connect the power adapter to the
router, then plug it into an outlet.
Wait until the Wireless LED turns
solid green.
If none of the LEDs light, make sure that the
Power On/Off button is in the on position
(pushed in).
Step 3.
Plug in, then turn on your modem.
Wait approximately 2 minutes
until your modem turns on.
If your modem has a battery backup,
first remove and reinsert the battery
before connectiong your modem to power
.
Step 5.
Connect the router
to your computer.
Use anouter Ethernet cable to establish
a wired connection as shown in this diagram.
(Optionally) Connect wirelessly by using the
preset wireless security settings located
on th bottom label.
Step 6.
Open a browser.
If the web page does not display,
close and reopen the browser and
enter http://www.routerlogin.net
in the address bar, or check the
“Troubleshooting” chapter of the
user manual.
AC750 Wireless Dual
Band Gigabit Router
(not included)
To Next Page
Need help?
General
