NETGEAR R7800 User Manual (English)

To Next Page

Quick Start

Nighthawk X4S

AC2600 Smart WiFi Router

Model R7800

IMPORTANT: Unplug your modem, remove and replace the backup battery if it

uses one, and then plug the modem back in.

Use the Ethernet cable to connect the modem to the yellow Internet port on the

router.

Connect the router to a power source. The router’s Power LED

lights amber

and then turns white when the router is ready.

Make sure that the router’s WiFi LED

is lit. Find the router’s preassigned WiFi

network name and password on the label on the router.

Open the WiFi connection manager on your computer or other WiFi-enabled

device, find the router’s WiFi network name, and use the router’s password to

connect.

Launch a web browser. If the NETGEAR installation assistant does not display, visit

www.routerlogin.net. If a login window opens, enter admin for the user name and

password for the password.

Follow the NETGEAR installation assistant.

To determine where to attach the antennas, match the labels on the antennas with the

labels on the router.

Attach and tighten the antennas on the threaded antenna posts.

Position the antennas as shown.

Package Contents

Router

Antennas (4)

Ethernet cable

2. Restart Your Modem and Plug In Your Router

3. Connect to the Internet

1. Attach the Antennas

Power adapter

(varies by region)

Need help?

Do you have a question about the NETGEAR R7800 and is the answer not in the manual?

NETGEAR R7800 Specifications

General

WiFi Technology	802.11ac
WiFi Range	Very large homes
Ethernet Ports	5 x 10/100/1000 Mbps Gigabit Ethernet ports (1 WAN & 4 LAN)
Antenna	4 external antennas
Beamforming	Yes
MU-MIMO	Yes
RAM	512 MB
Flash Memory	128 MB
WiFi Performance	AC2600 (800 Mbps + 1733 Mbps)
Processor	1.7 GHz dual-core
Security	WPA/WPA2
Dimensions	285 x 184.5 x 50 mm
Weight	1.65 lb (750 g)