Need help?Do you have a question about the Netis WF2220 and is the answer not in the manual?
General| Wireless Standards | IEEE 802.11b/g/n |
|---|---|
| Frequency Band | 2.4 GHz |
| Maximum Wireless Speed | 300 Mbps |
| Antenna Type | Fixed |
| Antenna | 2 x 5 dBi |
| Button | Reset |
| LED Indicator | Power, WLAN, LAN |
| Frequency Range | 2.4GHz - 2.4835GHz |
| Ethernet Ports | 1 x 10/100Mbps |
| Security | WEP, WPA |
| Operating Modes | Access Point, Client, Repeater |
| Power Supply | 5V/1A |
Details the status and color indications for PWR, Turbo, WPS, and LAN LEDs.
Explains how to use the access point to create wireless networks from an Ethernet connection.
Details how to bridge or repeat signal from an existing wireless network.
Used to change signal strength between Normal and High Power modes.
Used to restore the device's factory default settings.
Used to establish a secured wireless connection via WPS.
Procedure to reset the access point to factory default settings using the Default button.
Troubleshooting steps if unable to access the access point's web management interface.
Detailed steps for setting up the access point using Power over Ethernet (PoE).
Instructions for manually setting a static IP address on computers for Windows and macOS.
Explains two methods to adjust wireless power: using the Turbo button or the web management page.
Information regarding FCC compliance, RF exposure limits, and operating conditions.
Provides toll-free numbers and email addresses for technical support in different regions.
To Next Page
