The LED Light
The LED light on your Pixie-Z1 has seven possible statuses:
Blinking in white:
the Pixie-Z1 is waiting for configuration
(in its HOST mode).
Flashing red quickly five times: press and hold the button for
five seconds to reset the Pixie-Z1, the Pixie-Z1 will flash red quickly
five times, then start to blink in white.
Flashing red quickly twice: the Pixie-Z1 is unable to connect to
the paired Hub.
Flashing in green: searching for nearby Hub.
Solid white: found the hub and will try to connect to the hub.
Solid green: when the Hub is successfully connected to the WiFi
network, the light turns solid green for five seconds.
Solid blue: the Pixie-Z1 is watering.
-8-
To Next Page
Loading...