Netum DS Series User Manual

Firmware Version:
Firmware version will be displayed by scanning “$SW#VER”.
Netum barcode scanners are factory programmed for the most common terminal and
communications settings. If you need to change these settings, programming is
accomplished by scanning the bar codes in this guide. An asterisk (*) next to an
Barcode Programming:
option indicates the default setting.
$SW#VER
Some command barcodes only work in a particular connection mode.
Pay attention to below symbols when you scanning command barcodes.
Command barcodes only apply to scanner work via Bluetooth.
Important Notes ①
Command bacodes only apply to scanner work via 2.4G Wireless.
-2-
(
RFID Function
1) Connect reader with your device. Refer to page 4-7 (Connection way)
(2) Setup corresponding keyboard language. Refer to page 8-9 (Keyboard
language)
Below instruction only apply for DS8100
Steps on triggering a RFID reading

Netum DS Series Specifications

General

Brand	Netum
Model	DS Series
Category	Rfid Systems
Language	English