4.2 Automatic identi�ication label
Shutdown the printer; open the cover, load the paper and close the cover, boot the
printer, to be a normal printer initialization is completed (about 3-5 seconds). Press
Paper Feed button and hold it until you hear playing the "drip " after the release, the
printer automatically execution tab of the Automatic identi�ication.
4.3 Device self-test
In standby mode the printer, and the paper is loaded perfectly, press and hold the
button, until you hear playing the "drip ... drip ..." twice after release, the printer can
be check by self
4.4 Paper Installation
4.5. paper jamming treatment
The below �igure shown open the cover to remove paper; check the viscose fouling
on the head of printer. If have a viscose, fouling ,please clean it with alcohol. After
dry, you could print.
High temperature after working,
be aware of burns.
Tip: Self-priming paper
High temperature
(3)
To Next Page
Loading...
