NetWave ComNet NWK1 User Manual

INS_NWK1_NWK2_QS_REV– 07/7/15 PAGE 1
QUICK START GUIDE
INDUSTRIAL OUTDOOR 802.11A/N WIRELESS ETHERNET KIT
Thank you for purchasing NetWave
®
from ComNet. This quick start guide is designed to
walk you through installation.
This guide applies to the following models:
NWK1: Industrial Point to Point Kit, FCC Version (Includes NWK1_AP and NWK1_CL)
NWK2: Industrial Point to Point Kit, ETSI Version (Includes NWK2_AP and NWK2_CL)
An easy to read LED array displays unit operational status along with received signal
strength ensuring optimal installation and operation. See Figure 2 on Page 2 for LED
Indicator explanations.
See Figures 3 through 5 beginning on Page 3 for mounting instructions.
This manual serves the following
ComNet Model Numbers:
NWK1
NWK2

NetWave ComNet NWK1 Specifications

General

Wireless Standard	IEEE 802.11b/g/n
Frequency Band	2.4 GHz
Wireless Speed	Up to 300 Mbps
Antenna	2 x 5dBi External Antennas
Ports	1 x 10/100 Mbps Ethernet Port
Security	WEP, WPA/WPA2
Operating Modes	Access Point, Repeater
Operating Temperature	0°C to 40°C

Summary

Status Indicators

LED Indicator Explanations

Details of LED visual cues and their indications for unit status, including power, LAN, and signal strength.

Installation Instructions

Step 1: Prepare Mounting Hardware

Determine mount type (pole/wall) and prepare included hardware for installation.

Step 2: Route Ethernet Cable

Pass the RJ45 connectorized Ethernet cable through the weather-tight gland connection.

Step 3: Secure Weather Assembly

Install the weather proof assembly over the cable and tighten the cap.

Step 4: Connect Cables and Power

Connect Ethernet cables to PIM and access point, then connect power.

Pole Mount Instructions

Vertical Mount Positions

Illustrates vertical pole mounting in -45° and +45° positions.

Configuring Netwave

Initial Connections and Power

Connect cables to PIM, NetWave unit, and power the system.

IP Address Configuration

Set laptop IP static and access device via default IP.

Login and Network Settings

Login with default credentials and configure LAN IP settings.

Wireless Settings

Configure wireless mode, country code, SSID, RF power, and security.

Advanced Configuration and Defaults

MAC Lock Configuration

Enable MAC-Filter to lock to specific client radios.

RSSI and Signal Strength

Understanding Received Signal Strength Indicator (RSSI) for connection quality.

Reset to Factory Default

Procedure to reset the radio to factory default settings.

Topology Examples

Typical Point-to-Point

Diagram of a typical point-to-point wireless Ethernet link.

Dual Port Topology

Diagram of point-to-point topology utilizing dual ports.

Agency Compliance

FCC and Industry Canada Compliance

Statements regarding FCC and Industry Canada compliance rules.

RF Exposure and CE Marking

RF exposure warnings and CE marking information.

Installer and Disposal Requirements

Installer responsibility and RoHS/WEEE compliance statements.