16
Chapter 5: Using the Setup
Wizard
The Network Everywhere Wireless Cable/DSL Router comes with an automat-
ed software installation procedure for Windows 98 SE, Me, 2000, and XP. This
will configure the Router when connecting it for the first time. Thereafter, con-
figuration can be set through the Web Utility.
Insert the Setup Wizard CD into your CD-ROM drive. Unless you have deac-
tivated the auto-run feature of Windows, the screen shown in Figure 5-1 should
appear automatically.
This screen presents you with all of the options provided by the Setup Wizard
CD. These options include:
Set Up Your First Computer This option is used for configuring the Router
for use with your wireless devices.
Before You Start
The Setup Wizard’s Title Screen
Figure 5-1
4. Select Internet Protocol
(TCP/IP) (as shown in
Figure 4-7) and click the
Properties button.
5. Select Obtain an IP
address automatically and
verify that Obtain DNS
server address automati-
cally is selected (as shown
in Figure 4-8). Then, click
the OK button and click the
OK button on the subse-
quent screens to complete
the PC’s configuration.
Repeat steps 1-5 for each PC on your network. When all of your PCs are
configured, proceed to Chapter 6:The Router’s Web-based Utility.
Figure 4-7
Figure 4-8
Wireless Cable/DSL Router
Network Everywhere
®
Series
15
To Next Page
Loading...