Scanner Appliance Tour
Ethernet Port Configuration
44
5 When the REALLY SET LAN TO <value> prompt appears, press ENTER to store
the configuration setting. Go to Step 9 unless WAN port configuration is necessary
for split network configuration.
Split Network Configuration: When the Scanner Appliance has a split network
configuration, you have the option to configure the WAN port link setting. To do
this, follow the steps below.
6 Press the Down arrow one time. The WAN PORT LINK option is displayed along
with the WAN port link setting in effect.
7 Press the Right arrow to advance through the available port link settings.
Tips - Use the Left arrow to advance through the settings in reverse order. To quit
this procedure and return to SETUP NETWORK, press the Up arrow two times.
8 When the desired WAN port link setting is displayed, press ENTER to confirm the
configuration setting.
9 When the REALLY SET WAN TO <value> prompt appears, press ENTER to store
the configuration setting.
10 Return to SETUP NETWORK.
A change to an Ethernet port setting takes effect right away.
Setting Description
AUTO Auto negotiation
1GbaseT/Full 1GbaseT (1 gigabit) full-duplex data transmission
100baseT/Full
100baseT full-duplex data transmission
100baseT/Half
100baseT half-duplex data transmission
10baseT/Full
10baseT full-duplex data transmission
10baseT/Half
10baseT half-duplex data transmission
To Next Page