8
Step 3
• Press the [STAY] key.
• The stay light
will illuminate indicating that all interior zones are
bypassed. (All
interior devices will bypass automatically, giving the
user freedom of movement within the interior area.)
• The bypass light
will illuminate if any zone(s) are bypassed. If any
zone(s) have been bypassed previously by the user, the light(s)
corresponding to the bypassed zone(s) will illuminate, alerting the
user that a
zone(s) may be unprotected and can be faulted without
an alarm.
Step 4
• To toggle from a “delayed entry” mode to an “Instant” mode
the [STAY] key again.
• The instant light will illuminate indicating that the entry/
have no entry delay.
USING THE QUICK ARM (Optional, see page 1)
The Quick Arm feature may be used if it is enabled. Quick Arm will allow the user
to arm the security system in the AWAY mode by pressing the [EXIT] key, or arm
in the STAY mode by pressing the [STAY] key. The keypads beep during the
exit delay; beeps rapidly for the last 10 seconds of the exit delay; and beeps 1
second at the end of the exit delay. This feature is used for ARMING ONLY, and
will not disarm the security system. This is ideal for a maid or baby sitter code,
etc.
CHANGING MODES WHILE SYSTEM IS ARMED
Pressing the [STAY] key will turn on/off (toggle) a delay on entry/exit doors
and turn on/off (toggle) the instant light.
(Optional) Press the [BYPASS] key at this time to turn on/off (toggle) all
designated interior zones.
(Optional) When armed, pressing the [EXIT] key will start the exit delay,
enabling you to leave the building.
IMPORTANT
The instant light needs to be off at this time if you plan on re-entering the
building; otherwise you will create an alarm. You may restore an entry
delay by pressing the [STAY] key again.
DISARMING THE SYSTEM
When you enter the protected area through one of the designated Entry/Exit
doors, the keypad control will sound a continuous tone for the duration of the
entry delay time, or until you enter a valid code. The red armed light will go off
and the tone will stop. The security system is now DISARMED. If a valid code is
not entered before the end of the entry delay, an alarm will occur. (NOTE: If the
red armed light is flashing during the entry delay, the alarm system has
been activated in your absence. Leave the building immediately and call
your alarm company and/or the police from a safe location.)
To Next Page
Loading...
General