Need help?Do you have a question about the Neumann.Berlin TLM 103 and is the answer not in the manual?
Details microphone variants and XLR connector pin assignments for balanced output.
Lists available Neumann cables for the TLM 103, noting length impact.
Explains 48V phantom power requirements and compatibility.
Details requirements for using P48 phantom power supplies and specific Neumann units.
Describes battery-powered units for supplying phantom power when mains are unavailable.
Addresses connecting to unbalanced inputs and potential issues with grounding.
Recommends elastic suspension to prevent mechanical vibrations.
Describes stand mounts and adapters for mounting microphones.
Details an auditorium hanger for suspending microphones.
Lists various table and floor stands for microphone placement.
Explains foam windscreens for reducing wind noise and pop.
Describes pop screens for suppressing plosive sounds.
General| Acoustic operating principle | Pressure gradient transducer |
|---|---|
| Polar Pattern | Cardioid |
| Frequency Response | 20 Hz - 20 kHz |
| Sensitivity at 1 kHz into 1 kohm | 23 mV/Pa |
| Rated Impedance | 50 ohms |
| Equivalent Noise Level, A-weighted | 7 dB-A |
| Max SPL for THD 0.5% | 138 dB |
| Signal-to-Noise Ratio, A-weighted | 87 dB |
| Supply Voltage | 48 V ± 4 V |
| Current Consumption | 3 mA |
| Weight | 450 g |
| Type | Condenser |
| Rated Load Impedance | 1 kohm |
| Power Requirement | 48 V phantom power |
| Connector | XLR-3 |
To Next Page
