User manual
Turn the ends of the jumper cables around the battery
terminals
several times to ensure good contact.
6. Now start the excavator. If it does not start immediately,
start the
engine of the assisting vehicle to avoid draining the starting
battery.
7. After the excavator has been started and is running
evenly, have
another person
¨ disconnect the jumper cables from the battery of
the
started engine, first disconnect cable from
negative
terminal (-) and then from positive terminal (+),
and
disconnect the jumper cables from the battery of
the
assisting vehicle, first disconnect cable from
negative terminal (-) and then from positive
terminal (+).
¨
Ensure that the cables do not short circuit
(touch).
Ensure that the excavator alternator has sufficient time to
charge
the battery before setting the excavator in motion or
stopping the
engine.
Make sure the cloth is removed and screw the filler caps
back on.
9707672_user manual_en
- 49 -
To Next Page
Loading...