NSLP 3.7 A1
■ 6
│
GB
│
IE
│
NI
│
CY
WARNING! RISK OF INJURY!
► Do not use the "Polish" mode on milk teeth.
CAUTION! PROPERTY DAMAGE!
► The electric toothbrush may only be recharged with the
supplied charger.
Otherwise, the appliance could be irreparably damaged!
► Operate the appliance only with the original accessories
supplied.
Only the use mains adapter/charger/appliance indoors.
Before first use
1) Clean the appliance as described in the section "Cleaning" to remove any
transport dust. Dry it thoroughly.
2) Place the appliance on a stable and level surface.
Set-up/wall bracket
NOTE
► The charger may only be operated free-standing if used in dry rooms.
► In damp rooms, especially in the vicinity of water (bath), the charger
must be firmly fixed to the wall to protect it from falling into water.
1) Use the screw holes - of the charger to mark the spacing for the drill
holes on the wall. Check to ensure that there is a mains power socket in the
immediate vicinity.
2) Before drilling the holes, check to ensure that there are no electrical cables
or water pipes behind the markings.
3) Use a 5 mm drill bit to drill the marked holes and push the wall plugs % in.
4) Affix the wall bracket using the screws + provided.
5) Ensure that the power cable is not trapped and that it lies properly in the
cut-outs.