.SPL-10 Mesh Coil 1.0Ω X1
.Type-C cable X1
.User manual X1
.Warranty Card X1
USE INSTRUCTION
1. Install the Coil
Take out the coil from the package, and insert the coil firmly into the pod.
2. Replace the Coil
2.1 Please confirm the POD is empty before replacing coil.
2.2 Pull out the used coil
2.3 Install a new coil firmly
3. Fill the E-liquid
-Uncover the silicone plug at the side of POD.
-Gently insert the e-liquid filling bottle tip to the filling slot and press down
to squeeze the e-liquid through the slot.
-Please wait for 5 minutes for the e-liquid to soak into the coil.
4. Power on the Device
Click the power button 5 times in 2 seconds to power on (the LED indicator
will be flash from the L1 to L3) then press the key button to start vaping or
just inhale directly.
5. Start Vaping
Pressing the firing button or just inhaling both can enjoy the extremely
smooth vaping experience. The auto-draw function and firing button could
be switched freely and no button pressing.
6. 3 Levels Voltage adjustable
Within the power on status, continuously pressing the firing button 3
times to enter the voltage adjustment status. The L3 light will be on when
the voltage is in 3.1V, the L3 and L2 light will be on when the voltage in
3.4V, all the 3 LED lights will be on when the voltage is 3.7V.
To Next Page
Loading...