7. Charging the Battery
After connecting the Type-C cable to the battery, the LED indicator will
flash from L1-L2-L3 when the power is 0-30%, the L1 light will be firmly on
and the L2 and L3 will be flash when the power is 30%-70%, L1 and L2 will
be firmly on but the L3 will be flash when the power is 70%-90%, All the 3
LED lights will be on once the power reaches 90%-100%. Once fully
charged, the LED lights will be off. You could enjoy vaping during the
charging.
8. Power status
When vaping, all the 3 LED indicators will be on when the power is
70%-100%, the L1 and L2 will on when the power is 30%-70%, the L1 will
be on when the power is 0-30%.
9. Settings
1. Power on / off: Press the button 5 times in 2 seconds to power on(the LED
indicator will be flashed from L1-L2-L3) or power off( LED indicator willthe
be flashed from L3-L2-L1) the device.
2. Adjust the airflow: Pull out the cartridge and rotate it 180 degrees to change the
airflow.
3. 3 Levels voltage adjustment: Continuously pressing the firing button 3
times to adjust the voltage, total 3 levels valtage adjustment: 3.1V, 3.4V
and 3.7V and the related LED lights will be on to show it when adjusting.
4. Dormant state: Without operation for 1 seconds, press any key to
wake up.
PROTECTIONS
1. Overtime Protection: Intelligent overtime protection will avoid
atomizer's coil and cotton being burned.
To Next Page
Loading...