Need help?Do you have a question about the New Communications Solutions NCS-3230 Multi-Rx and is the answer not in the manual?
General| Brand | New Communications Solutions |
|---|---|
| Model | NCS-3230 Multi-Rx |
| Category | Receiver |
| Language | English |
Connects Multi-Rx to Multi-Switcher for station control, including mic switching.
Specifies power connector type, voltage, current, and correct polarity for the unit.
Describes the POWER switch, MUTE ALL button, and BUSY indicator LEDs.
Explains the function of Left and Right channel switches in Normal and Spatial modes.
Details RECORD SELECT switches, RECORD controls (MAN/VOX, ENABLE), and RECORD ON LED.
Describes SPEAKERS switch, PHONES jack, BALANCE/VOLUME controls, and MODE switch.
Details AUDIO IN jacks and MIXER OUT/AMP IN jacks for audio and external equipment.
Explains SPEAKER jacks and the DATA connector for muting and computer interface.
Describes RECORDER, MUTE, and PWR connectors for audio, muting, and power.
Guidance on setting audio levels and selecting between Normal and Spatial operation modes.
Details configuring for recording and connecting for external computer control.
Explains how to get switch status and send commands via serial interface.
Discusses causes and solutions for hum (magnetic coupling, ground loops) and noise.
Addresses audio distortion causes and provides NCS contact information for support.
Summarizes front panel controls and rear panel connections for quick reference.
Details power requirements (voltage, current) and physical dimensions of the unit.
To Next Page