Need help?Do you have a question about the NEW ENERGY NERS-G50Y-B1 and is the answer not in the manual?
General| Model | NERS-G50Y-B1 |
|---|---|
| Category | Heat Pump |
| Heating Capacity | 5.0kW |
| Noise Level (Outdoor) | 52dB(A) |
| Weight (Outdoor Unit) | 35kg |
| Power Supply | 220V-240V/50Hz/1Ph |
Shows the physical appearance of the heat pump unit.
Details technical specifications like heating/cooling capacity, power input, and COP.
Provides dimensional drawings and measurements for the heat pump units.
Shows a breakdown of the unit's components with numbered parts.
Lists necessary equipment and considerations before installing the heat pump.
Provides guidelines for choosing an appropriate and safe location for unit installation.
Illustrates the recommended piping and filtration circuit layout for the heat pump.
Details the setup for connecting two heat pump units in parallel for increased capacity.
Explains how to connect the power supply wires and provides wire size specifications.
Lists checks to perform before starting the heat pump for the first time.
Introduces the control functions and operation of the unit.
Explains how to use the primary buttons and functions on the control panel.
Describes how to manually initiate the defrosting cycle for the unit.
Explains how to manually activate the electric heating function.
Details the procedure to reset the unit's settings to their factory defaults.
Guides users on how to access and modify system parameters.
Lists available system parameters, their set ranges, and factory settings.
Lists error codes, their descriptions, and suggested solutions for system protection issues.
Shows the display interface of the Wi-Fi module and its indicators.
Connect to Wi-Fi, install app, and configure network settings for remote control.
Instructions for launching the app, registering accounts, and configuring Wi-Fi.
Provides steps for connecting the heat pump to the Wi-Fi network.
Explains how to operate the heat pump through the "Smart Life" app interface.
Guides on how to share control of the heat pump with other users.
Explains how to switch between different operating modes (heating, cooling).
Instructions on setting timers for automatic operation of the heat pump.
Steps to remove the device from the app and network.
To Next Page
