New England Arbors EZ User Manual

4” / 5” EZ Mount Post for Arbors
ASSEMBLY INSTRUCTIONS
Check Box for These Contents
In the event of missing or defective parts please call our customer service department at
1 800 282 9346 (Mon. to Fri. 8:00 AM to 4:00 PM EST).
Please read through before starting installation.
V1.0/082718
1
1.
2.
3.
Removable Donut (2) 4in Part Number 11145 / 5
in Part Number 11148
Pipe Anchor Assembly (1) Ø1 5/8” x 26 1/8” - 11147
5/8” (16mm) Self-Augering Stainless Steel Screw (4) 20016
3
2
Tools You Will Need
· Sledge Hammer (5 or 10 lbs)
· Cordless Drill with Phillips Bit
· Spirit Level
· Adjustable Wrench
· Tape Measure
17 in [43.1cm]
9 1/8 in [23.2 cm]
Ø3 3/4 in [9.5cm] for 4” EZ Mount
Ø4 3/4 in [12.1cm] for 5” EZ Mount
Ø1 5/8 in
[4.1 cm]

New England Arbors EZ Specifications

General

Brand	New England Arbors
Model	EZ
Category	Racks & Stands
Language	English

Summary

Assembly Preparation

Check Contents

Verify all listed parts are present before starting installation.

Tools Required

List of necessary tools for assembling the arbor post.

Step One: Install Pipe Anchor

Locate and Mark

Mark the center of the four posts according to arbor instructions.

Drive Pipe Anchor

Drive the pipe anchor post into the ground, ensuring it is level.

Adjust Donuts

Reinstall top donut and adjust bottom/top donuts for pipe alignment.

Step Two: Attach Arbor to Posts

Position Arbor Assembly

Slide the arbor assembly onto the installed pipe anchors.

Fasten Posts

Secure each post using the provided screws into the bottom donut.