Need help?Do you have a question about the New England Arbors Lenox and is the answer not in the manual?
General| Brand | New England Arbors |
|---|---|
| Model | Lenox |
| Category | Accessories |
| Language | English |
Guidance for assembling and installing the pergola kit, advising on tools and modifications.
Advice on site selection, placement relative to the house, and checking local building codes.
Specifies that the product is not designed for additional weight loads like swings or people.
Instructions for measuring and marking post locations using string lines and stakes for square installation.
Details on excavating post holes, placing wood posts, ensuring they are level and cut to height.
Marking bracket locations and drilling 3-inch deep holes for concrete screws.
Setting wood posts into installed brackets and securing them with screws, ensuring proper height.
Attaching post shims to the wooden posts on all four sides near the bottom and top.
Attaching slide lock brackets and inserting wood post guides into main column posts.
Guiding vinyl columns over wood posts, adjusting heights, and securing them with screws.
Attaching post slide brackets to beam ends, ensuring correct orientation and fastening with screws.
Attaching post slide brackets to beam ends and fastening them securely with screws.
Attaching rafter slide brackets to rafters and fastening them with screws.
Assembling decorative end caps by inserting them into post slide brackets and fastening.
Sliding beam and rafter assemblies into position between the posts.
Sliding the decorative end cap assemblies onto the ends of the posts.
Assembling shade slats by joining two slats with a joiner without screws.
Installing shade slats at specific spacing and securing them to rafters with screws.
Temporarily fitting brace brackets onto braces and positioning them for marking.
Attaching beam brace brackets, sliding braces into post brackets, and securing with screws.
Placing the post caps onto the top of the posts as the final assembly step.
To Next Page