Need help?Do you have a question about the New Holland 615 and is the answer not in the manual?
General| Brand | New Holland |
|---|---|
| Model | 615 |
| Category | Lawn Mower |
| Language | English |
Explains DANGER, WARNING, and CAUTION symbols for personal safety.
Details IMPORTANT statements for machine safety and preventing damage.
Identifies and explains the placement and meaning of safety decals on the machine.
Initial checks and preparations before operating the mower for the first time.
Recommended checks and maintenance after the initial 8 hours of machine use.
Specifies necessary tractor horsepower, PTO, hydraulic, and hitch requirements.
Step-by-step guide on connecting the mower to the tractor's three-point hitch and PTO.
Details on fitting, shortening, and connecting the PTO assembly.
Guides on adjusting limit chains and hitch pin height for alignment.
How to adjust hitch pins to match tractor tread width for correct alignment.
Steps to prepare the mower for transport, securing curtain and engaging latch.
Procedure for safely detaching the mower from the tractor.
Guidance on how to start cutting a field, beginning with the back swath.
Instructions on cutting square corners and general field cutting practices.
Adjustments and precautions for operating in rough, stony, or debris-ridden fields.
How to adjust flotation using limit chains and spring length.
Method for changing cutting height by adjusting the top link angle.
Explanation of the breakaway system and how to reset it.
Guidelines on lubrication intervals, types of lubricants, and general maintenance practices.
Instructions for greasing fittings, including type of grease and frequency.
Procedures for checking and changing oil in the bevel gearbox.
Instructions for checking and changing oil in the drive modules.
Table of torque values for metric non-flanged hardware and locknuts.
Explains markings on bolts and nuts for identification.
Procedures for installing adjustable fittings and torque data for hydraulic tubes.
How to check, adjust, and replace the drive belt for proper operation.
Adjusting the breakaway latch spring for different conditions and troubleshooting.
Guidance on inspecting discs for damage, wear, and proper replacement procedures.
How to inspect the cutter bar for damage, including knives, discs, and module alignment.
Regular inspection of knives and bolts for wear, damage, and proper torque.
Instructions for replacing or turning knives and information on different knife styles.
Procedures for replacing worn or broken rock guards and skid shoes.
Steps for proper storage of the mower, including cleaning, greasing, and belt removal.
Diagnosing and correcting vibration and cutter bar floating problems.
Troubleshooting machine breaking back too easily and achieving correct cutter bar angle.
Resolving problems with stubble, drive belt, and excessive power consumption.
Information on the right swathboard kit for narrowing the cut swath.
Details on the left swathboard kit for narrowing the cut swath.
How to install the high stubble kit for increased cutting height, and subsequent adjustments.
Overview of different New Holland knife types and their recommended uses.
Technical details on cutting width, height, tilt, operating range, and discs.
PTO requirements, input speed, driveline protection, belt tension, and hitch types.
Physical dimensions and weight specifications for the mower models.
To Next Page