E215C-E245C INTRODUCTION
IN - 2
PAGE NUMBER
• Each page has a number, located on the central lower side of the page. Each page number contains the
following information:
Example: T 1-2-3
Consecutive page number for each group
Group number (if exist))
Section number
T: Technical Manual
W: Workshop Manual
SYMBOLS
In this manual, the following safety alert symbol and signal words are used to alert the reader to the potential
for personal injury or machine damage.
This is the safety alert symbol.
When you see this symbol, be alert to the potential for personal injury.
Never fail to follow the safety instructions prescribed along with the safety alert symbol.
The safety alert symbol is also used to draw attentio in to component/part weights.
To avoid injury and damage, be sure to use appropriate lifting techniques and equipment when lifting
heavy parts.
UNITS USED
SI Units (International System of Units) are used in this manual.
MKSA system units and English units are also indicated in parentheses just behinds SI units.
Example: 24.5 MPa (250 kgf/cm
2
)
A table for conversion from SI units to other system units is shown below for reference purposes.
Quantity
To convert from
(SI)
Into
(Others)
Multiply by Quantity
To convert from
(SI)
Into
(Others)
Multiply by
Lenght mm in 0.03937 Pressure MPa
kgf/cm
2
10.197
mm ft 0.003281 MPa psi 145.0
Volume L US gal 0.2642 Power kW CV-PS 1.360
L US qt 1.057 kW HP 1.341
m
3
yd
3
1.308 Temperature °C °F °C x 1.8 + 32
Mass kg lb 2.205 Velocity km/h mph 0.6214
Force N kgf 0.10197
min
-1
rpm 1.0
N lbf 0.2248 Flow rate L/min US gpm 0.2642
Torque N.m kgf.m 0.10197 mL/rev cc/rev 1.0
N.m lbf.ft 0.7375
Find manuals at https://best-manuals.com
To Next Page
Loading...
Need help?
General
