Need help?Do you have a question about the New Holland LM1340 TURBO and is the answer not in the manual?
General| Brand | New Holland |
|---|---|
| Model | LM1340 TURBO |
| Category | Construction Equipment |
| Language | English |
All maintenance and repair interventions must be performed exclusively by the Manufacturer's Service Organization.
Procedures for the complete overhaul of the gearbox assembly.
A guide to help diagnose and resolve common gearbox issues.
Detailed instructions for overhauling the front axle.
Procedures for overhauling individual front axle components.
Step-by-step guide for removing the rear axle assembly.
Procedure for adjusting the brake discs.
Details and specifications for the hydraulic pump.
Section containing various electrical circuit diagrams.
Precautions and procedures for the correct installation of seals.
Explanation of the alert symbol and its importance for safety.
Never clean, lubricate, or maintain a machine while it is in motion.
Required protective gear for welding and burning operations.
Keep hands and fingers away from moving parts and wear appropriate protection.
Procedure for safely opening the radiator cap to release pressure.
Warning about hazardous high-pressure fluid leaks and medical attention.
Importance of checking tyre inflation pressure per manufacturer specifications.
Location and importance of the vehicle serial number.
Do not unseal AC systems; they contain gases harmful to the atmosphere.
Consequences of clogged, squeezed, or deformed hoses on performance.
Never disconnect or tighten lines under pressure; check line status first.
Do not use general values if manual specifies different torque or procedure.
Table of minimum tightening torques for metric bolts and lock nuts.
Table of minimum tightening torques for inch measurement screws and lock nuts.
Manual data may vary; consult dealer for specific machine information.
Diagrams and dimensional data for LM1340, LM1343, LM1345 models.
Load chart for LM1340, LM1343, LM1345 without stabilizers or raised.
Load chart for LM1343 with stabilisers in lowered position.
Diagrams and dimensional data for LM1443, LM1445 models.
Load chart for LM1443, LM1445 with raised stabilisers and rear axle lock.
Load chart for LM1443 with stabilisers in lowered position.
Diagrams and dimensional data for LM1745 model.
Load chart for LM1745 with raised stabilisers and rear axle lock.
Engine maximum torque output specification.
Temperature at which the thermostat starts to open.
Details regarding the type and function of the injection pump.
Specifications for the T 12000 4x3 powershift transmission.
Technical specifications for the starter motor.
The diameter of the brake discs used in the system.
The hydraulic system pressure for steering operations.
Information on the availability of a differential lock for the front axle.
Description of rear axle swing and auto-locking at >10° boom angle.
Specifies the main system pressure for the hydraulic system.
Specified torque value for tightening wheel nuts.
Antifreeze must be changed every 1000 hours or 24 months.
Tables are for reference only; consult dealer for specific tyre information.
Tyre pressures and axle weights for LM1340, LM1343, LM1345 models.
Tyre pressures and axle weights for LM1443, LM1445 models.
Tyre pressures and axle weights for LM1745 model.
Guidance for selecting engine oil viscosity based on ambient temperature.
Recommended engine oils, their specifications and quantities.
Recommended oils for the powershift transmission.
To Next Page
