SECTION 1 - GENERAL
INFORMATION
16. Remove the rear cab post bolts,
4,
two or four
bolts each side.
NOTE:
If
the rear bolts,
4,
have spacers
under the bolt heads, they must
be
reinstalled during reassembly for proper
torquing.
A
CAUTION: NEVER LOOSEN
OR
REMOVE
ANY CAB RETAINING HARDWARE
BEFORE THE JACK ASSEMBLY
IS
INSTALLED.
17. Jack cab and boom assembly over with the
loader properly supported off the ground.
Support the boom at 1 , to support the boom
and cab to preventtipping of the loader when
heavy components, engine, hydrostatic
pumps, etc. are removed from the lower
frame. Jack travel will limit the travel of the
cab assembly to prevent over travel. Be sure
all wire harnesses, hydraulic hoses, and
throttle cable clear any obstructions during
cab tilting.
A
WARNING: NEVER ATTEMPT
TO
TILT
THE SKID-STEER LOADER
CAB
WITHOUT PROPER INSTRUCTIONS AND
USING THE PROPER TOOL. SEE THE
SERVICE MANUAL AND/OR YOUR NEW
HOLLAND DEALER.
CAUTION: NEVER ATTEMPT TO
OPERATE
OR
MOVE THE SKID-STEER
LOADER WITHOUT FIRST INSTALLING
AND PROPERLY TIGHTENING
ALL
CAB
RETAINING HARDWARE.
1-23
Figure 1-18
Figure 1-19
To Next Page
Loading...