New Holland Lx985 - Tilting Cab and Boom Back on Frame

SECTION 1 - GENERAL INFORMATION
TILTING CAB AND BOOM BACK ON
FRAME
To jack the cab and boom assembly back into
position, do the following:
1. Pull the hydrostatic control handles forward
and hold
in this position with rubber tie straps
from the handle to the front cab post.
2. Jack the cab and boom back into position.
3. Keep the wire harness, 1 and throttle cable,
2, in position to prevent damage from setting
the cab
on them.
4. Pull the wire harness through the loop, 3.
A
CAUTION: KEEP THE WIRE HARNESS
FROM BEING DAMAGED. A DAMAGED
WIRE HARNESS COULD RESULT
IN
DAMAGE TO THE LOADER ELECTRICAL
COMPONENTS.
5. Remove rubber tie straps from the
hydrostatic control handles.
6. Reinstall all cab support bolts front and rear.
NOTE: If the rear bolts, 1, had spacers
under the bolt heads, they must be
reinstalled during reassembly for proper
torquing.
Torque the rear bolts, 1, to 80 ft. lbs. (108
N·m).
7. Reinstall the parking brake linkage, 2.
8. Position the throttle cable, 3, inside frame.
1-24
Figure 1-20
Figure 1-21