EasyManua.ls Logo

New Holland T4.105F - User Manual

New Holland T4.105F
248 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
OPERATOR’S MANUAL
Part number 47593719
2
nd
edition English
October 2013
Replaces part number 47494640
T4.75F
T4.85F
T4.95F
T4.105F
Tractor
ORIGINAL INSTRUCTIONS

Table of Contents

Questions and Answers

  • E
    Erin GouldNov 21, 2025
    Why won't my New Holland Tractor start?
    • T
      Timothy BaldwinNov 21, 2025
      There are several reasons why your New Holland Tractor might not be starting. It could be due to an incorrect starting procedure, a low or empty fuel level, or air in the fuel system. Also, check if the engine oil viscosity is correct and that you're using the appropriate fuel for the ambient temperature. Other potential causes include a contaminated fuel system, a clogged fuel filter, a fuel injector fault. Finally, make sure the battery isolator is disconnected and the fuse or relay are not faulty. You can check the fuel level, bleed fuel system, use oil of right viscosity, use correct type of fuel for temperature conditions, clean system, replace filter element, disconnect the battery isolator, check and if necessary change the fuse or the relay. For a fuel injector fault you should con...
  • R
    Rebecca LawrenceAug 25, 2025
    How to reduce excessive fuel consumption in New Holland T4.105F?
    • D
      dunnwhitneyAug 26, 2025
      To address excessive fuel consumption in your New Holland Tractor, start by ensuring you are using the correct fuel type. Check and maintain the air filter, and avoid engine overload by using a lower gear or reducing the load. Also, check and adjust the valve clearance, and ensure your equipment is correctly adjusted. Other factors include low engine temperature (check the thermostat), excessive ballast (adjust to the correct weight). For clogged fuel injection nozzles you should contact your dealer.
  • V
    valerierosalesAug 27, 2025
    What causes New Holland T4.105F batteries not charging?
    • T
      Tracey DixonAug 27, 2025
      If the batteries in your New Holland Tractor are not charging, the issue might be loose or corroded terminals. Clean and tighten them. Also, verify that the battery charge is at least 12.6 V and check the electrolyte level and specific gravity. A loose or worn belt can also prevent charging, so check the belt tensioning device and replace the belt if necessary.
  • K
    Kevin WoodAug 27, 2025
    How to prevent excessive oil consumption in New Holland Tractor?
    • K
      Kristin BensonAug 27, 2025
      To prevent excessive oil consumption in your New Holland Tractor, make sure the oil level isn't too high; reduce it if necessary. Also, use oil with the correct viscosity. Check for and repair any oil leaks. Finally, replace the breather pipe filter if it's clogged.
  • D
    Dr. Michael ContrerasAug 28, 2025
    What causes hydraulic fluid overheating in New Holland T4.105F?
    • J
      Jill GrahamAug 28, 2025
      Hydraulic fluid overheating in your New Holland Tractor can stem from several causes. The fluid level may be too high or too low, so top up the oil as needed. A clogged fluid filter element can also contribute, so replace the filter. For issues such as incorrect flow regulation, a radiator block, a stuck spool valve, or a relief valve venting, you should contact your dealer.
  • L
    Lynn ContrerasSep 16, 2025
    Why does the hydraulic lift operate slowly in draft control in New Holland Tractor?
    • D
      Dominique AllenSep 16, 2025
      If the hydraulic lift operates slowly in draft control on your New Holland Tractor, the combined draft/position control may be incorrectly set. Adjust the combined draft/position control. If the lowering speed is too slow or the implement is not working properly, have the control valve checked or adjust implement settings.
  • A
    Andre ParkerSep 14, 2025
    Why is the air conditioning not cooling properly in my New Holland Tractor?
    • B
      Brandon DixonSep 14, 2025
      If the air conditioning in your New Holland Tractor isn't cooling properly, start by cleaning the radiator, oil exchanger, and condenser, as a clogged condenser can cause this issue. If the refrigerant is low, check the glass port to see if there are bubbles visible and contact your dealer. Also, check the automatic belt-tensioning device and the state of the compressor belt to ensure it's not slipping or damaged. Finally, make sure the heating is off by turning the temperature control fully anti-clockwise for maximum cooling.
  • K
    Kenneth MosesSep 15, 2025
    What to do if the linkage does not move when the control lever is actuated in New Holland Tractor?
    • G
      Gina TaylorSep 15, 2025
      If the linkage on your New Holland Tractor doesn't move when you actuate the control lever, make sure the linkage cylinder tubes are connected correctly. Also, check for a linkage overload and reduce the load if necessary.
  • J
    John GouldSep 6, 2025
    What causes abnormal engine knocking in New Holland Tractor?
    • D
      David TannerSep 6, 2025
      Abnormal engine knocking in your New Holland Tractor can be caused by a low oil level, so top up the fluid level. If the oil pressure is low, you should contact your dealer.
  • K
    Kristi VillanuevaSep 4, 2025
    What to do if New Holland Tractor starter motor does not work?
    • K
      Kimberly GuerreroSep 4, 2025
      If the starter motor on your New Holland Tractor isn't working, first ensure that the gear lever is in neutral. Next, check for loose or corroded connections and clean and tighten the terminals. Finally, if the batteries are totally flat, charge or replace them.

Summary

2 SAFETY INFORMATION

Safety rules and signal word definitions

Explanation of safety alert symbols, signal words, and their meanings.

Safety information

General precautions for safe operation and maintenance.

Cab guard

Information on cab categories and operator protection.

Personal protective equipment (PPE)

Fire or explosion prevention

Getting in and out of the machine

4 OPERATING INSTRUCTIONS

COMMISSIONING THE UNIT

STARTING THE UNIT

Procedures and precautions for starting the engine.

STOPPING THE UNIT

Procedures for stopping the tractor and engine safely.

5 TRANSPORT OPERATIONS

ROAD TRANSPORT

Safety precautions and procedures for transporting the machine.

RECOVERY TRANSPORT

Guidelines and warnings for towing the tractor.

7 MAINTENANCE

GENERAL INFORMATION

General safety precautions before performing maintenance.

Fuel supply

MAINTENANCE CHART

Scheduled maintenance actions based on hours or time intervals.

ELECTRICAL SYSTEM

CALIBRATIONS

8 TROUBLESHOOTING

FAULT CODE RESOLUTION

Table of fault codes, symbols, and their meaning.

TROUBLESHOOTING ENGINE

Common engine problems, possible causes, and corrections.

Electrical system - Troubleshooting ELECTRICAL SYSTEM

Troubleshooting common electrical system issues.

Hydraulic systems - Troubleshooting HYDRAULIC SYSTEM

Troubleshooting common hydraulic system problems.

Rear three-point hitch - Troubleshooting HYDRAULIC LIFT AND 3−POINT LINKAGE

Troubleshooting issues with the rear hydraulic lift and 3-point linkage.

ALARM(S)

Description of alarms, their causes, and possible solutions.

9 SPECIFICATIONS

Dimensions and weights

Maximum permitted loads on front and rear axle

Recommended operating load capacities for axles.

Technical data

Engine, fuel system, lubrication, and cooling specifications.

New Holland T4.105F Specifications

General IconGeneral
MakeNew Holland
ModelT4.105F
CategoryTractor
Fuel TypeDiesel
Number of Cylinders4
3-Point Hitch CategoryII
Horsepower105 hp
EngineFPT NEF
TransmissionDyna-6

Related product manuals