SECTION 4 -- LUBRICATION AND MAINTENANCE
4--4
ACCESS FOR
INSPECTION AND MAINTENANCE
INTRODUCTION
To access the engine components and carry out
inspection, lubrication and maintenance operations,
the bonnet (hood) must be opened.
The following instructions describe the procedure to
be followed.
1
BONNET (HOOD)
The bonnet is hinged at the rear to allow easy and
safe access to the various engine components.
One gas strut (1) fig. 2 holds the engine bonnet in
one of the two possible positions.
1
TRE0046A
2
OPENING THE BONNET (HOOD)
Pull the lever upwards (1) fig. 3, lift from the front, and
allow the bonnet to raise. The gas strut (1) fig. 2 will
maintain the bonnet in the raised position.
NOTE: To close the bonnet, simply pull it down and
press the top lightly to ensure it engages.
1
TRE0828A
3
To Next Page
Loading...
