Models: Travel Berkey
Big Berkey - Royal Berkey
Imperial Berkey
Crown Berkey™
®
®®
®
Introduction:
Now that you have bought your water filter, you have taken
the first step towards protecting you and your family from disease causing
pathogens, parasites and other waterborne contaminates.
The ease of operation of this unit combined with a proven
effectiveness at eliminating waterborne diseases such as cholera and
typhoid, has led to this filter being specified for field operations by many
of the world’s major aid and emergency relief organizations.
Berkey
®
Contents:
1- Upper Chamber 1- Lower Chamber
1- Spigot, nut and two washers
0-6 Blocking Plugs
Actual components may vary slightly from drawing.
1. Extreme cleanliness is important. Wash hands and system before proceeding to assure
that contamination of the components does not take place during assembly.
2. Remove the filter elements and parts from their protective packaging, checking
each item against the above list.
Note: The number of elements supplied will depend on the type of unit ordered.
3. Fit the onto the by inserting the up through the hole in the lid
and screwing on the knob. Hand tighten only.
4. Place the large sealing over the threaded portion of the .
5. Place the into the hole inside the base of the upper chamber (4).
6. Secure element in the chamber base by screwing on the onto the
threaded mount. Repeat #4,5&6until all elements have been installed.
7. For systems having more filter holes than filter elements (expandable systems),
secure into empty holes. Blocking plugs may vary; insert rubber
plug into each hole, screw together white blocking plug (top & bottom).
8.Place the beveled exterior washer (8) onto the threaded portion of the outlet
with the beveled side facing the system hole and the flat side facing the .
9. Insert thread of through hole in the side of the .
Place the second small over the thread within the chamber and
secure in place with the . Tighten securely by hand only.
10. Place the onto the and place in
Position.
1- Lid, knob and screw
1- Assembly instruction sheet
(depending on model)
2-8 Filter elements, wing nuts and washers (depending on model)
For the last 1/4 turn, hold
the nut in place and gently turn the spigot until it is tight.
NOTE:
knob (1) lid (2) screw (3)
washer (10) element (5)
element (5)
wing nut (11)
blocking plugs (12) NOTE:
spigot (7)
spigot (7)
spigot (7) lower chamber (6)
washer (8)
nut (9)
upper chamber (4) lower chamber (6) lid (2)
Assembly Instructions:
STAINLESS ASSEMBLY-01-18 - © Copyright - 1998-2018 - New Millennium Concepts, Ltd. All rights Reserved.
NEW MILLENNIUM CONCEPTS, LTD.NEW MILLENNIUM CONCEPTS, LTD.
Berkey
Water Filters
®
“Simply the Best”
Notes:
1) If the system is left to stand for more than 3 days, it
is recommended that any water left in the lower
chamber be run to waste and the water filtered during
the first 1 minute also be run to waste.
2) When installing filter elements for the first time or
replacing used elements, it is important to condition the
new filters using the below procedure.
3) Spigot styles may vary slightly.
WARNING: Failure to read, thoroughly understand, and follow all instructions may result
in personal injury, water damage, or voiding of the warranty! It is the assembler’s
responsibility to make sure all components are properly assembled and installed using
the instructions provided. While your system should not have any leaking
problems, there is always the chance that a leak might occur due to being improperly
assembled or perhaps a faulty part. In an overabundance of caution, we recommend that
for the first 24 hours the filled system be placed in an area wherein if such a leak were to
occur, the resulting spillage would not damage anything within the household.
Berkey
®
IMPORTANT OPERATIONAL NOTE:
When lower chamber is partially filled, be cautious not to overfill upper chamber as
this could cause lower chamber to overflow. For example, if the lower chamber is 1/3
full the upper chamber can be refilled by 2/3rds, if the lower chamber is ½ full, the
upper chamber can be refilled by ½, etc.