New One AR270 - Operating Controls and Features; Location of Controls; Sound Features and Adjustments; Listening to the Radio

GB - 3 GB - 4
1. Button: To turn unit on/o󰀨; To mute or restore sound
2. MOD/CLK button: To select function mode; To set clock time
3. VOL/SEL knob: volume, select, enter knob
4. skip forward
5. LCD display
6. USB port
7. AUX IN jack
8. TF card slot
9. RES (RESET) button
10. skip backward
11. AMS/P+: Preset stations+; Automatic storing; Search a track
Turn on/o󰀨 the unit
Press
button to turn on the unit. Press and hold this button again to turn o󰀨 the unit.
Selecting the mode
When the unit is on, press MOD/CLK button repeatedly to select di󰀨erent source mode:
RADIO USB SD AUX IN
Note: USB, SD mode cannot be selected if no such source was plugged in the unit.
Current time display
Long press MOD/CLK button to display the current time when unit is ON.
Adjust time:
1. Press and hold MOD/CLK button to enter into setting mode. The hour digits will ash.
2. Rotate volume knob anti-clockwise and clockwise to adjust the hour value. Press MOD/CLK button
again to conrm the hour value.
3. The minute digits will ash, rotate volume knob anti-clockwise and clockwise to adjust the minute
value. Press MOD/CLK button to conrm.
Noted: It will conrm your setting if no key is pressed within 5 seconds.
Reset the unit
Operating the unit for the rst time or after replacing the car battery, you must reset the unit. To set the
unit to initial status, press RES button on the front panel with a pointed object. When some errors occur
in display, you can also reset the unit, but it will erase the clock setting and some memorized functions.
LOCATION OF CONTROLS
BASIC OPERATIONS
Volume adjusting:
To increase or decrease the sound level, rotate VOL/SEL knob clockwise or anti-clockwise.
Muting the sound
When the unit is ON, press
to mute the sound. Press again to restore.
Using VOL/SEL knob to select sound feature
Repeatedly press VOL/SEL knob
To select the desired mode for sound setting in the following order: “BAS” (BASS)
“TRE” (Treble)
“BAL” (Balance) “FAD” (Fader) EQ OFF/ CLASS (CLASSICS)/ ROCK/ POP/ FLAT
LOUD ON/ OFF
DX/ LOC STEREO/MONO 12H/24H.
After selecting the desired mode, you can adjust the level by rotating the volume knob.
Preset equalizer (EQ)
When you are listening to pop music, classic music or rock music or Flat music, use the equalizer to
adjust the sound quality. Repeatedly press volume knob to select “EQ OFF” and rotate volume knob
to select di󰀨erent equalizer mode in following order: BASS
TRE BAL FAD EQ
LOUD
RPT INT RDM 12H/24H SONG.
Switching Loudness On/o󰀨
By this function, you can increase the low frequency, which can improve sound sensitivity.
Noted: Please refer to “LISTENING TO THE RADIO” for others items operation.
SOUND FEATURES
Selecting band
In tuner mode, repeatedly press AMS/P+ button to select bands in following order: FM1 (P1-P6)
FM2 (P1-P6)
FM3 (P1-P6).
Manual / automatic tuning
- Manual Tuning
Press
or continuously to select a station downward or upward.
- Automatic Tuning
Long press or button, the radio automatically searches a station upward or downward
respectively and plays when it nds a station.
Scanning and memorizing stations
- By AMS/P+ button
In tuner mode, press and hold AMS/P+ button for 3 seconds to start scanning for stations and store
them automatically in memory. All preset stations are scrolled during few seconds under your selected
band.
- By VOL/SEL button
1. Tune to a station by
or .
2. Press and hold VOL/SEL button for 2 seconds until display shows the “S-P1”, using the VOL/SEL
to choose the target position.
3. Press VOL/SEL button to conrm the stored station.
4. When you are listening to a station stored, press AMS/P+ button repeatedly to choose the stored
station.
Note: The unit can be stored up to 6 stations for each band.
LISTENING TO THE RADIO