NEW POS NEW 8110 User Manual

Manual for HotSpot Printer
Table of Contents
1. Buttons..................................................................................................................2
2. Menu structure...................................................................................................................4
3. Configuration description .................................................................................................8
4. Installing new software........................................................................................10
5. Set time and date................................................................................................12
6. Restore to default setting....................................................................................13

NEW POS NEW 8110 Specifications

General

Memory	2GB RAM
Touch Panel	10-point Capacitive Touch
Card Reader	Magnetic stripe
Connectivity	Wi-Fi, Bluetooth
Camera	5MP
Printer	58mm Thermal Printer
Ports	USB

Summary

Menu Structure Overview

AP Configuration

Configure wireless network settings like access point, SSID, and security.

IP Configuration

Configure printer IP address, subnet mask, and gateway.

Mikrotik (MT) Configuration

Tariff Configuration

Custom Configuration

Configuration Description

Mikrotik Device Configuration

Steps required for configuring the Mikrotik device for HotSpot.

HotSpot Printer Configuration

Steps to configure the HotSpot printer for Mikrotik integration.

Software Installation Guide

Preparation and Software Setup

Connect printer, boot, enter diagnostic menu, and launch InitTool software.

Printer Model and Software Download

Refresh printer model and download new software using InitTool.

Finalizing Firmware Update

Setting Time and Date

Accessing Diagnostic Menu

Entering Date and Time

Input new date and time using the YYMMDDHHMMSS format.

Saving and Exiting

Restore Default Settings

Printer and Software Preparation

Connect printer, boot, enter diagnostic menu, and launch InitTool.

Initial Software Configuration

Model Refresh and Application Info

Deleting Existing Software