EasyManua.ls Logo

NewAir ACP-1300H - User Manual

NewAir ACP-1300H
5 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
ACP-1300H Portable Air Conditioner
Owner's Manual
Please read all instructions carefully before operating
1.Safety Instructions
(1) Warning................................................................................... 2
(2) Precautions.............................................................................. 3
(3) Maintenance......................................... ................................... 4
2. Parts List
(1) ACP-1300H Unit and Accessories...............................................5
(2) Control Panel ........................................................................... 6
(3) Remote Control......................................................................... 7
(1) Operating the ACP-1300H for the First Time; Operating Modes;
and Thermostat.........................................................................8
(2) Setting the Timer.......................................................................9
(3) Adjusting the Airflow...................................................................9
(4) Installing the Battery for the Remote Control...............................10
(5) Emptying the Auxiliary Water Tank.........................................11-12
(6) Setting up the Exhaust Hose.................................................13-14
4. .......................................................................15
5. ..........................................................................16
6. ................................................................ 17
3.Operating Instructions
Troubleshooting Tips
Electrical Diagram
Electrical Specifications
Contents
1
Connect the ACP-1300H's plug into an
appropriate power outlet.
Do not turn off the power supply by
pulling the power cord; use the On/
Off power button.
Make sure the air conditioner's ground
wire is connected.
If you notice smoke or an odd odor coming
from the ACP-1300H, turn the unit off and
disconnect the power plug.
To avoid injury, keep fingers and foreign
objects out of the unit.
1. Safety Instructions
Warning
If problems persist or if the unit malfunctions, please contact your NewAir
dealer or a professional repair center.
Before operating the ACP-1300H,
make sure your hands are clean and dry.
2
Be careful not to damage the power
cord, and do not operate the ACP-1300H
if the cord appears to be damaged.
Do not use a power strip or an extension
cord.
Precautions
1. Safety Instructions
3
Leave the ACP-1300H in an upright position for at least two hours before operating.
The unit must be installed in accordance with national and local wiring regulations.
The ACP-1300H's supply cord requires a Y-type attachment. If the supply cord is
damaged, it must be replaced by the manufacturer, an authorized service agent, or a
qualified repair professional in order to avoid further damage, to prevent voiding the
warranty, and to avoid bodily injury.
Never operate the ACP-1300H in an area where flammable gasses or chemicals are
present.
To prevent electromagnetic interference, place the unit at least three feet away from
radios or televisions.
When connecting or disconnecting the power cord, hold the plug itself - never pull the
power cord.
When not using the unit for an extended period of time, disconnect the power cord and
drain any water from the auxiliary water tank.
When cleaning the ACP-1300H, do not spray liquid directly onto the unit. Moreover,
do not use harsh chemicals or cleansers to clean the unit. Instead, apply water or a
mild cleanser to a soft cloth and wipe the ACP-1300H clean.
The ACP-1300H is not intended to support heavy objects, be used as a step-stool, or
be shaken or bumped into. Keep this in mind when deciding where to place the unit.
If you choose to use the continuous drain function on the ACP-1300H, make sure the
condensate can drain off into an appropriate receptacle.
To ensure adequate air circulation, place the air conditioner at least four inches away
from walls and furnishings. Be aware of draperies or other items which may interfere
with the intake vents and cause restricted airflow.
Place the ACP-1300H on a level, flat surface. Do not operate the unit on an angle of
more than 4 inches.

Table of Contents

Questions and Answers

  • J
    johnwagnerJul 29, 2025
    What to do if my NewAir ACP-1300H Air Conditioner doesn't work?
    • G
      Gregory CollinsJul 29, 2025
      If your NewAir Air Conditioner isn't working, first, ensure the power cord is correctly connected. If that doesn't solve the issue, reset the circuit at the breaker box. You can also try changing the socket or outlet. If these steps fail, take the unit to a qualified technician to replace the fuse (fuse specification: 3A/250V).
  • M
    Mary MoranAug 2, 2025
    Why does my NewAir Air Conditioner stop working on its own?
    • C
      Casey PattonAug 2, 2025
      Your NewAir Air Conditioner might stop working on its own because the timer has been activated, so turn the timer off. Alternatively, the room temperature may be lower than the set temperature; in this case, wait for the room temperature to rise.
  • B
    Bryan MooreAug 7, 2025
    Why is there no cool air coming out of my NewAir ACP-1300H when it is in cooling mode?
    • G
      Gregory GarciaAug 7, 2025
      If no cool air is coming out of your NewAir Air Conditioner in cooling mode, it could be due to two reasons: 1. The room temperature is lower than the set temperature. Wait for the room temperature to rise to resume normal operation. 2. The evaporator is frosted over. Allow the evaporator to defrost, and normal operation will resume.
  • C
    Carol BoydAug 11, 2025
    Why is there no cool air coming out of my NewAir Air Conditioner when it is in dehumidifying mode?
    • B
      brittanybradfordAug 11, 2025
      If your NewAir Air Conditioner isn't producing cool air in dehumidifying mode, it could be because: 1. The evaporator is frosted. Allow it to defrost for normal operation. 2. The unit is eliminating frost. Allow the evaporator to defrost and normal operation will resume.
  • E
    Emily RamirezAug 15, 2025
    What to do if error code E1 is displayed on my NewAir ACP-1300H Air Conditioner?
    • F
      frank96Aug 15, 2025
      If error code E1 appears on your NewAir Air Conditioner, it could be due to high voltage. Try restarting the unit when the voltage returns to normal. If the problem persists, the unit might be damaged, and you should have it repaired by your NewAir dealer or a professional repair center.
  • K
    kevinmitchellAug 19, 2025
    What to do if error code E2 is displayed on my NewAir ACP-1300H Air Conditioner?
    • J
      Jason Murray PhDAug 19, 2025
      If error code E2 is displayed on the control panel of your NewAir Air Conditioner, it means the water tank is full. Empty the water tank and restart the unit.
  • J
    Jordan LewisAug 25, 2025
    What to do if error code E4 is displayed on my NewAir ACP-1300H?
    • J
      John HallAug 25, 2025
      If error code E4 is displayed on the control panel of your NewAir Air Conditioner, the coil pipe is damaged. Replace the coil pipe.

Summary

Safety Instructions

Warning and Precautions

Covers critical safety warnings, unit placement, installation, and operational precautions to prevent hazards.

Parts Identification

Unit Components and Accessories

Lists and identifies all physical parts and accessories included with the ACP-1300H unit for reference.

Control Panel and Remote Overview

Explains the display panel icons, control buttons, and the functions of the remote control unit.

Operating Procedures

Initial Setup, Modes, and Thermostat

Guides through initial power-on, selecting operating modes, and adjusting the temperature for comfort.

Timer, Airflow, and Battery Management

Instructions for programming the timer, adjusting airflow direction, and replacing remote control batteries.

Water Tank Drainage Procedure

Details the steps for emptying the water tank when the unit signals it is full to maintain operation.

Exhaust Hose Setup

Exhaust Hose Installation and Guidelines

Provides instructions for connecting the exhaust hose for efficient cooling, including hose length recommendations.

Troubleshooting

Common Problems and Suggested Solutions

Offers guidance for resolving typical issues like the unit not working or stopping unexpectedly.

Electric Diagram

Control Panel Wiring Diagram

Presents a schematic illustrating the electrical connections within the unit's control panel for technical reference.

Technical Specifications

Performance and Power Data

Details key specifications like cooling/heating capacity, power consumption, and noise level.

Physical and Operational Data

Includes water tank capacity, temperature set range, unit weight, dimensions, and refrigerant type.

NewAir ACP-1300H Specifications

General IconGeneral
BrandNewAir
ModelACP-1300H
CategoryAir Conditioner
LanguageEnglish

Related product manuals