Newell Rubbermaid DYMO XTL300 User Manual

1
Replacing the Cutter Blade
1 Press the label compartment release and lift the cover.
2 Remove the label cartridge.
3 Insert a straightened
paper clip (or other
pointed object) in the
small hole shown in the
figure below to release
the cutter mechanism.
4 While pressing the paper
clip down, pull the cutter
mechanism straight out
from the side of the label
maker.
The cutter blade is extremely sharp. Use caution when
handling the blade.
5 Insert the new cutter blade into the label maker and press
into place.
6 Dispose of the old cutter blade in a manner consistent with
local, regional, and national regulations.
7
ENG
Pull straight out
Press and hold

Newell Rubbermaid DYMO XTL300 Specifications

General

Brand	Newell Rubbermaid
Model	DYMO XTL300
Category	Label Maker
Language	English

Summary

Replacing the Cutter Blade

Prepare for Blade Replacement

Release the label compartment cover and remove the label cartridge.

Remove Cutter Mechanism

Use a paper clip to release the cutter mechanism and pull it out from the side.

Cutter Blade Safety Warning

The cutter blade is extremely sharp; use caution when handling the blade.

Install New Blade and Dispose Old

Insert the new cutter blade and dispose of the old one according to regulations.